What’s new in Solderstep
0.4.0-beta.0 · November 9, 2026
- Row-by-row mounting of modules: each row of pins goes in the board (soldered header), takes soldered wires on its pads, or is not used. The module lines up with the row placed in the board; a row that is misaligned or off the 2.54 grid cannot go in.
- The Free wire tool starts or ends on a module pad (gold rings), and nets follow.
- Module editor: describe your modules in mm (board, rows of pads, main component, colour), with a to-scale preview over the holes. They are kept in My library, and a project that uses them keeps a copy.
- PCM5102 back with its 15 pins; MAX98357 speaker pads; DS3231 second header.
0.3.0-beta.0 · November 8, 2026
- Solder side: components and jumpers can now sit under the board (a capacitor under a terminal block, a header pointing down to plug into an ESP32, a jumper underneath). Use “Board side” in their properties, or place them directly from the copper-side view (C).
- Checks updated: a bare wire on the solder side is flagged when it touches another net’s copper; a part may sit under a module on the other side.
- Checklist: new final step “Solder side: parts and jumpers”.
- Bill of materials (Wiring tab): parts of the whole project grouped by type and value, supplies (boards, jumper wire, cuts, wires, cables); CSV export and printing.
- Printable assembly report (or PDF): for each board both sides, its checklist with tick boxes and its checks, then connections, project-wide checks and the bill of materials.
- Automatic colours across the project: jumpers, wires between pieces and cable strands take their net’s colour, even when it is named on another board.
- “What’s new” window after an update, a What’s new section in the help and a page on the website.
0.2.0-beta.1 · October 26, 2026
- Feedback (by e-mail) and Support (a coffee on Ko-fi) buttons.
0.2.0-beta.0 · October 26, 2026
- Several boards in one project, with free components (power jack, front-panel LED, wired module) and soldered wires between them.
- Connections view: male/female matings and cables described pin by pin, Y cables included.
- Net names follow across the whole assembly; checks cover the whole assembly.
- Multi-board example, from the welcome screen or the help.
- Modules checked against the makers’ own files.
0.1.0-beta.0 · October 22, 2026